The Latest Gartner® Magic Quadrant™Hyperconverged Infrastructure Software
Moderators: anton (staff), art (staff), Max (staff), Anatoly (staff)
Any other work around for this sir??yaroslav (staff) wrote:To mark manually as synchronized
1. Stop StarWindService on all nodes.
2. Go to *_HA.swdsk
3. Set <sync_status>1</sync_status> for the HA device you need to mark as synchronized and <sync_status>0</sync_status>
4. Repeat appropriate changes for the opposite node.
5. Start the service.
If one node is not reachable, do that for the remaining one.
yaroslav (staff) wrote:See my previous comment or point refer the target to the imgfile, not HA device in StarWind.cfg.
I have HA Devices sir..yaroslav (staff) wrote:Do you have HA devices or Image devices? If so, those are to be listed nearby <targets> section (where their targets are listed).
Did you try this one?Go to SyncHaDevice.ps1 -> comment $device.Synchronize([SwHaSyncType]::SW_HA_SYNC_FULL, "") -> uncomment #$device.MarkAsSynchronized().
No siryaroslav (staff) wrote:Hi,
Thanks for more details on this case!Did you try this one?Go to SyncHaDevice.ps1 -> comment $device.Synchronize([SwHaSyncType]::SW_HA_SYNC_FULL, "") -> uncomment #$device.MarkAsSynchronized().
Have a great weekend!
yaroslav (staff) wrote:Hi,
Thanks for more details on this case!Did you try this one?Go to SyncHaDevice.ps1 -> comment $device.Synchronize([SwHaSyncType]::SW_HA_SYNC_FULL, "") -> uncomment #$device.MarkAsSynchronized().
Have a great weekend!