StarWind Software

Hi guys;

I'm just testing the MaintenanceMode.ps1 in our two node Starwind VSAN.
I've edited the $addr="127.0.0.1" with our first node ip: $addr="192.168.0.1".

After running the script both of our nodes went to Maintenance mode. Is this this the expected behaviour? I though only first node was going to be set to maintenance mode.

Maybe is because the $deviceName="HAImage1" is the same in both nodes?

Thanks in advance for the help.

Hi,

Yes, it is expected behavior. See more on Maintenance mode https://www.starwindsoftware.com/help/M ... eMode.html
See more on the restart steps https://knowledgebase.starwindsoftware. ... installed/.