StarWind Software

Posted: **Thu Jan 07, 2021 4:29 pm**

I'm really struggling a bit with the powershell scripts and managing to setup the environment for a 2-node HA with multiple luns. I can get a single HA target with one lun done fine. I can get multiple HA targets with 1 lun each fine, but what I cannot seem to figure out is how to add multiple luns to a single HA target using the CLI.. When I try it, I go into some kind of synchronization hell and have this error in the powershell console:
-
control 0x00000167A7F982C0 -InitSynchronize:"" -SynchronizationType:"3"
-
200 Failed: Operation cannot be completed. Can't send command to the partner node..

Does anyone have a guide on adding a second HA lun to an existing target?

Posted: **Fri Jan 08, 2021 7:00 pm**

Greetings,

Welcome to StarWind Forum. We do not recommend adding a second HA device to a target. That is why this seems to be hard to do via PowerShell.

Posted: **Fri Jan 08, 2021 8:26 pm**

Thank you for that information! I thought I was losing my mind,

Posted: **Sat Jan 09, 2021 4:08 am**

No worries, always here to help.

StarWind Software

Adding LUNS to existing HA target via CLI

Adding LUNS to existing HA target via CLI

Re: Adding LUNS to existing HA target via CLI

Re: Adding LUNS to existing HA target via CLI

Re: Adding LUNS to existing HA target via CLI