StarWind iSCSI SAN
StarWind Native SAN for Hyper-V
 

Completely new to configuring, 2 nodes sent to me

Pure software-based VM-centric and flash-friendly VM storage (iSCSI, SMB3, NFS, iSER and NVMe over Fabrics) including free version. Same software embedded on StarWind ready nodes.

Moderators: art (staff), anton (staff), Anatoly (staff), Max (staff)

Completely new to configuring, 2 nodes sent to me

Postby Wonk » Tue Nov 05, 2019 2:11 pm

Hi guys, hoping I can get some help here.

Back in April 2019 (as far as I can tell) some ex employees set up VSAN free across 2 nodes at one of our locations. I was hired in June, and they shipped me the two servers and want me to get it up and running. I have no idea how it was configured, or even what type of configuration. They are 2 HyperV 2016 Core hosts, and I imagine if I just get the IPs configured properly through the core menu, this thing can get back up and running, and I can poke around.

How can I tell what type of configuration these hosts had by looking at the IPs of the 4 interfaces per host?

Thanks in advance for any assistance.
Wonk
 
Posts: 1
Joined: Tue Nov 05, 2019 2:05 pm

Re: Completely new to configuring, 2 nodes sent to me

Postby Boris (staff) » Tue Nov 05, 2019 3:24 pm

You might probably want to go through this doc https://www.starwindsoftware.com/resour ... rver-2016/ and check how everything is configured on your side. Chances are this paper was used for servers configuration.
Boris (staff)
Staff
 
Posts: 806
Joined: Fri Jul 28, 2017 8:18 am


Return to StarWind Virtual SAN / StarWind Virtual SAN Free / StarWind HyperConverged Appliance / StarWind Storage Appliance

Who is online

Users browsing this forum: No registered users and 6 guests