Witness iSCSI targets
Posted: Wed Feb 13, 2019 9:16 am
Hi,
In a hyperconverged 3-node scenario, which targets should I connect to the Witness device?
In the tutorial (https://www.starwindsoftware.com/resour ... erver-2016) for a 2-node, there is a text that says:
I think that I should connect Witness only to the local 127.0.0.1 IP, and left the other 2 nodes partner targets disconnected. Is that correct?
Thanks,
Enric
In a hyperconverged 3-node scenario, which targets should I connect to the Witness device?
In the tutorial (https://www.starwindsoftware.com/resour ... erver-2016) for a 2-node, there is a text that says:
In the 3-node tutorial (https://www.starwindsoftware.com/resour ... -v-cluster) this text is missing, but in the screenshot on how should it looks like, if shows the Witness connected to 2 nodes, which I don't understand.NOTE: It is recommended to connect Witness Device only by loopback (127.0.0.1) address. Do not connect the target to the Witness Device from the StarWind partner node.
I think that I should connect Witness only to the local 127.0.0.1 IP, and left the other 2 nodes partner targets disconnected. Is that correct?
Thanks,
Enric