HA Devices Won't Resync After Reboot
Posted: Sat Feb 09, 2019 7:09 pm
Earlier this morning one of my nodes stopped syncing with the other. Everything on the node which experienced the issue effectively shut off and operations continued as normal.
I now have both systems back online and for the past hour and a half watched the first of nine HA devices synchronize. However at this point no further synchronization is happening and I can't manually kick off the sync like I typically could in the past calling the "SyncHADeviceAdvanced.ps1" script.
I am seeing a bunch of this in the node that is currently online and showing good.
2/9 16:51:36.087 1af0 HA: CHAPartnerNode::SendPartnerNodeVersionRequestCommand: Try to get partner node version through heartbeat channel.
2/9 16:51:36.087 1af0 HA: *** CHAPartnerISCSIChannelManager::SendCustomControlScsiCommand: Valid channel not found!
2/9 16:51:36.087 1af0 HA: *** CHAPartnerNode::SendPartnerNodeVersionRequestCommand: EXITing with failure, SendCustomControlScsiCommand(HA_CHANNEL_TYPE_HEARTBEAT) failed, error code 1168, scsi status = 0!
2/9 16:51:36.087 1af0 HA: *** CHAPartnerNode::SendForwardClientDataOutCommand: EXITing with failure, partner node version 0x0 is not supported or invalid. Nothing will be sent!
That basically repeats over and over.
I will admit that before the reboot patches were applied to the system (stupid mistake on my part) and I toyed with the idea of running a StarWind update, however I read that the software should be in a complete sync status before running the patch, so I dropped out of the installer. Perhaps that is causing the sync block?
Any assistance would be great.
I now have both systems back online and for the past hour and a half watched the first of nine HA devices synchronize. However at this point no further synchronization is happening and I can't manually kick off the sync like I typically could in the past calling the "SyncHADeviceAdvanced.ps1" script.
I am seeing a bunch of this in the node that is currently online and showing good.
2/9 16:51:36.087 1af0 HA: CHAPartnerNode::SendPartnerNodeVersionRequestCommand: Try to get partner node version through heartbeat channel.
2/9 16:51:36.087 1af0 HA: *** CHAPartnerISCSIChannelManager::SendCustomControlScsiCommand: Valid channel not found!
2/9 16:51:36.087 1af0 HA: *** CHAPartnerNode::SendPartnerNodeVersionRequestCommand: EXITing with failure, SendCustomControlScsiCommand(HA_CHANNEL_TYPE_HEARTBEAT) failed, error code 1168, scsi status = 0!
2/9 16:51:36.087 1af0 HA: *** CHAPartnerNode::SendForwardClientDataOutCommand: EXITing with failure, partner node version 0x0 is not supported or invalid. Nothing will be sent!
That basically repeats over and over.
I will admit that before the reboot patches were applied to the system (stupid mistake on my part) and I toyed with the idea of running a StarWind update, however I read that the software should be in a complete sync status before running the patch, so I dropped out of the installer. Perhaps that is causing the sync block?
Any assistance would be great.