StarWind Software

Hi,

I installed StarWind Virtual SAN Free on a two node Hyper-V cluster running on Windows Server 2016 Standard. I followed the guides on how to set this up, and the cluster had been running fine for a few weeks.

However, over the weekend, both the hosts had crashed and were unavailable this morning. A hard reset was required on both hosts to access them again.

Now, the iSCSI targets are no longer connecting on either of the servers. They're all stuck in 'Reconnecting...' status.

Any tips or guides on how to troubleshooting this issue and recover the cluster from powershell? Any help would be appreciated.

Ping me anton AT starwind DOT com and I'll get you in touch with engineers to see what happened and how to fix it.

larslj wrote:Hi,

I installed StarWind Virtual SAN Free on a two node Hyper-V cluster running on Windows Server 2016 Standard. I followed the guides on how to set this up, and the cluster had been running fine for a few weeks.

However, over the weekend, both the hosts had crashed and were unavailable this morning. A hard reset was required on both hosts to access them again.

Now, the iSCSI targets are no longer connecting on either of the servers. They're all stuck in 'Reconnecting...' status.

Any tips or guides on how to troubleshooting this issue and recover the cluster from powershell? Any help would be appreciated.

Thank you Anton. I'll contact you by email.

Quick update.
The issue has been resolved and Production restored.
This KB article was very helpful in this case: https://knowledgebase.starwindsoftware. ... -blackout/