IQN Name Change
Posted: Tue Sep 13, 2016 1:49 am
Is it possible to change the target IQN Name once its been generated?
Hello jhonken,
It is impossible to change the target IQN Name once it was created.
Alternatively, you can follow the steps below:
-turn off Production on existing target and disconnect it from iSCSI Initiator;
-remove device under existing target;
-add device back as Existing Virtual Disk and Choose the Targert Attachment Method as Unassigned. Use Add Device (advanced) wizard to complete it. It will be added without target;
-add the new target with the correct name;
-right click on the newly created target and Add existing Device to Target from appeared list;
-connect new target in iSCSI initiator and turn on Production.