StarWind Software

All,

I have been test-driving Starwind for some time now.

My setup is 2x HP DL360 G7. Each DL360 has one RAID5 set over 8x300GB 10K SAS. One 60GB partition for OS, 2012 R2 + Hyper-V and one 1,85TB partition for Starwind. One dedicated 1GB link for replication and one link for heartbeat. Both connection are crossed (no switch in between).

All is working fine. Only I have a lot of logging which I do not understand. A lot of "Skip 2 bytes..." lines in log files.

Below some logging. What does it mean?

1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...
1/27 12:21:28.971 1654 C[37c], LIN: Skip 2 bytes...

Regards,

Gerard

Hi Gerard!
Thank you for posting your question on StarWind online community.
You can disregard those messages since they are diagnostical, and intended for L3 troubleshooting if required, which is not your case. Moreover, we will remove this message from L1 logging to do not confuse users.
Please let me know if there is anything else that I might help you with