Software-based VM-centric and flash-friendly VM storage + free version
Moderators: anton (staff), art (staff), Max (staff), Anatoly (staff)
-
almatador
- Posts: 4
- Joined: Thu Mar 27, 2008 9:15 am
Thu Mar 27, 2008 9:35 am
hi all,
i have two cluster nodes and one machine for iscsi target. on the cluster nodes is a initiator installed. All works correct, but when the target machine down or turned off then the cluster could not accses the resources, the cluster don't work more.
my question :
how can i creat high availbilty for iscsi target machine ?
is it possibel to set up one intiator to more than one iscsi targets?
regd,
almatador
-
almatador
- Posts: 4
- Joined: Thu Mar 27, 2008 9:15 am
Fri Mar 28, 2008 6:14 pm
Hello Bohdan,
thank u for replying
i did read the manual about the HA iscsi target for MS cluster
in the manual configuration was discribed the configurations requriments:
two nodes and a shared disk resource.
where must be created first the shared disk resourse F:\? on the first node or on the second node.
in the manual is discribed that starwind will be referred to the F:\
it is assumed that befor configure the cluster, the shared disk F:\ must be configured on the first active node or on the second node?
regards,
almatador
-
Bohdan (staff)
- Staff
- Posts: 435
- Joined: Wed May 23, 2007 12:58 pm
Mon Mar 31, 2008 6:11 am
The shared disk resource F is either hardware storage with two interfaces or iSCSI storage server configured with StarWind.