sepperate raid into "LUNs"?
Posted: Thu Aug 16, 2007 4:47 pm
I just installed StarWind and I have to say that the installation is a breeze. And within minutes I was able to see the target from a workstation.
However what I need to do is partition this array into 2 areas. 1 being 200GB for my wife to store images from our cameras on and the remaining 1000ish GB for use with my 2 test ESX servers.
Ive been looking through the documentation and haven't seen anything about this yet. Am I missing what I am looking for?
However what I need to do is partition this array into 2 areas. 1 being 200GB for my wife to store images from our cameras on and the remaining 1000ish GB for use with my 2 test ESX servers.
Ive been looking through the documentation and haven't seen anything about this yet. Am I missing what I am looking for?
Thanks!