StarWind Software

I am trying to convert an old server out of one of our vhosts in VCenter into hyper V and when I run V2V and put in the credentials required I am not seeing any of the hosts or VMs to select.
Is this a permissions issue, if so I have admin rights within vcenter.

I am at a loss here since the logs aren't quite clear what could be causing this.

Welcome to StarWind Forum! Please try using ESXi host IP address instead.

Hi,

My colleagues tried different versions of V2V converter and we were able to list the VMs and disks.
Perhaps, this problem is related to permissions. Please make sure to use the administrator credentials.