StarWind Software

Hi,

I need you help to get percentage or size progress of image..

I'm using starwind in cmd to take vhdx format of a physical drive in a VM.
i tried this command (V2V_ConverterConsole.exe convert in_file_name="\\?\PhysicalDrive0" out_file_name="d:\disk.vhdx" out_file_type=ft_vhdx_thick) to get the output in vhdx format .. everything works fine and i'm getting the output.
But in my project. i need to know the progress of size or percentage of image before the stage of converting ..
i can see the progress while converting to vhdx, but before that stage while starwind taking the image i cannot see the progress in cmd, but there is no issue while using in GUI, its good .. but i need this to get into cmd..

Is there any idea to do with the above command to get progress , or is there any other idea to make it.. like any script file to get progress..
please help me..


Thanks ..

Hi Vijay,

I will request this feature. Thank you!

Hello yaroslav.

When we execute the starwind conversion command in cmd we are getting the percentage, But when we try the same command in any automation method (BAT file , script file etc ) we are unable to get the percentage

Thanks for the update ,any ETA on above mentioned..

Sorry, the request is not clear now.
Just to confirm we are on the same page: you are still getting the request when executing the individual command, but the percentile is not listed in BAT file.
Correct me if I am reading it wrong.