StarWind iSCSI SAN
StarWind Native SAN for Hyper-V
 

Windows 7 VM cannot run after conversion

VM image converter (VMDK, VHD, VHDX, IMG, RAW, QCOW and QCOW2)

Moderators: art (staff), anton (staff), Anatoly (staff), Max (staff)

Windows 7 VM cannot run after conversion

Postby Yukio Seki » Fri Aug 12, 2016 1:18 pm

Hi
I converted VMWare VM with Windows 7 OS (one disk 20 GB, full Windows update) to Hyper-V VM. So i used V2V converter. On Hyper-V cluster I created VM with the same settings as VMWare VM.
I attached converted disk and.... nothing... bluse screen. System cannot load.

VMWare virtual machine was version 8, virtual disk was attached to SCSI (0:0). I tried to use Microsoft Virtual Machine converter... the same situation.

What is going on? V2V converter cannot converts disk attached using SCSI to IDE (hyper-V VM generation 1 for Windows 7)?
Yukio Seki
 
Posts: 1
Joined: Fri Aug 12, 2016 1:12 pm

Re: Windows 7 VM cannot run after conversion

Postby Al (staff) » Fri Aug 12, 2016 3:51 pm

Hello Yukio Seki,

Thank you for your post.

Did you try to check box "Activate Windows Repair Mode" during the conversion?
Al (staff)
Staff
 
Posts: 43
Joined: Tue Jul 26, 2016 2:26 pm


Return to StarWind V2V Converter

Who is online

Users browsing this forum: No registered users and 2 guests