I have figured out the issues. CLI documentation is not correct and either needs to be updated or CLI fixed. out_host_address must have ip address. Documentation example shows a hostname. Hostnames will not work for this parameter. Nowhere is it mentioned an IP address must be used. If using CLI, yo...

One thing I noticed, with the vm already created, it created the drive in the datastore supplied. So it is authenticating successfully. It just fails immediately after creating it. Only when the VM doesn't exist previously does it give the error: VM VMName not found. Attempting to use a local accoun...

Should the VM already be created in VMWare prior to using the CLI? If so, where is that documented? Using the gui, it created the vm, converted the disk, and attached it. I created a vm to be sure without a disk. This time the result is a bit different. console message: Error attach Response is inco...

Using the GUI to convert a VM from Hyper-V to ESXi is working fine for both builds. However, I'm having issues with the CLI. The error messages on both builds are different even though I'm using the same parameters. Parameters entered as follows: V2V_ConverterConsole.exe convert in_host_type="w...