Search found 2413 matches

by yaroslav (staff)
Mon May 27, 2024 2:59 pm
Forum: StarWind Virtual SAN (VSAN) [+Free], HCI Appliance (HCA), Virtual HCI Appliance (VHCA) [+Free]
Topic: CVM “Initial Configuration” wizard
Replies: 2
Views: 37

Re: CVM “Initial Configuration” wizard

Thanks for your post and welcome to StarWind forum. Could you please explain what kind of issues you ran into?
by yaroslav (staff)
Mon May 27, 2024 2:53 pm
Forum: StarWind Virtual SAN (VSAN) [+Free], HCI Appliance (HCA), Virtual HCI Appliance (VHCA) [+Free]
Topic: Starwind vSAN Free vSphere ESXI Synchronizing stuck at 0%
Replies: 17
Views: 4294

Re: Starwind vSAN Free vSphere ESXI Synchronizing stuck at 0%

Thanks for your feedback. sync_from_first is to be used and it is a known problem. It should be addressed in the next build. Typically the event you shared points to the storage issues, however, here there might be difficulties with header/image creation that explains why only sync_from_first works....
by yaroslav (staff)
Mon May 27, 2024 8:31 am
Forum: StarWind V2V Converter, P2V Migrator
Topic: P2V to Azure, how to refresh?
Replies: 1
Views: 68

Re: P2V to Azure, how to refresh?

Yes, you can continue using the system that undergoes P2V.
The converter makes a shadow copy of the disk so that data will be up-to-date in the resulting VHDX.
by yaroslav (staff)
Sun May 26, 2024 1:52 pm
Forum: StarWind Virtual SAN (VSAN) [+Free], HCI Appliance (HCA), Virtual HCI Appliance (VHCA) [+Free]
Topic: Cannot synchronize after Blackout Virtual SAN Free
Replies: 3
Views: 66

Re: Cannot synchronize after Blackout Virtual SAN Free

Try marking sync_status 1 only the first occurance. Set the latter to 0.
Make sure to edit the files while StarWindService is stopped.
Last but not least, remove write back cache: should make such incidents less frequent.
by yaroslav (staff)
Sun May 26, 2024 9:08 am
Forum: StarWind Virtual SAN (VSAN) [+Free], HCI Appliance (HCA), Virtual HCI Appliance (VHCA) [+Free]
Topic: Cannot synchronize after Blackout Virtual SAN Free
Replies: 3
Views: 66

Re: Cannot synchronize after Blackout Virtual SAN Free

Stop the service on both nodes. Go to HA config files and ser sync status value in the config to 1 for the section that corresponds to the device. Do for each decice. That marks HAs as synchronized. Start the service on the node where you marked the devices as synchronized and check the data. If dat...
by yaroslav (staff)
Fri May 24, 2024 10:03 pm
Forum: StarWind V2V Converter, P2V Migrator
Topic: conversion VMware to Hyper fails
Replies: 6
Views: 211

Re: conversion VMware to Hyper fails

Can you please share the conversion logs with us here?
by yaroslav (staff)
Fri May 24, 2024 8:44 pm
Forum: StarWind V2V Converter, P2V Migrator
Topic: P2V into Windows 11 Hyper-V Manager
Replies: 1
Views: 59

Re: P2V into Windows 11 Hyper-V Manager

Welcome to StarWind Forum.
Both are correct. It all depends on what you are after. You converted a physical disk/volume into a VHDX that can be used either to create a new VM or connected to an existing one.
by yaroslav (staff)
Thu May 23, 2024 10:11 pm
Forum: StarWind V2V Converter, P2V Migrator
Topic: mount vhdx file
Replies: 12
Views: 1252

Re: mount vhdx file

Anatolii, Sorry for the delay. I also decided to simulate my situation again. I created a 2TB virtual disk (vhdx) using Windows tools. I created a partition on it that takes up all the space, format this disk and assign letter X:. I created several empty folders on the disk. Then did all the things ...
by yaroslav (staff)
Thu May 23, 2024 9:29 pm
Forum: StarWind V2V Converter, P2V Migrator
Topic: Issue with converting HyperV to ESXi
Replies: 23
Views: 1769

Re: Issue with converting HyperV to ESXi

Sorry for the delay. try out_file_type="ft_vmdk_esx_pre_allocated" instead of out_file_type=ft_vmdk_esx_thin The error ERROR: RunConsole: VM V2V-VMWARE-01 not found. describes the situation where the software converts the file and attaches it to the existing VM but fails as the VM does not...
by yaroslav (staff)
Thu May 23, 2024 9:19 pm
Forum: StarWind V2V Converter, P2V Migrator
Topic: VM to Hyper V Live Conversion.. Any Success?
Replies: 1
Views: 78

Re: VM to Hyper V Live Conversion.. Any Success?

Hi,

Sorry for the delay.
StarWind V2V converter makes only one snapshot.
It can convert live VMs. Let me know if you run into any trouble.