Sadly, no P2V for the 32-bit version anymore. Try older versions of disk2VHD.

No worries.
StarWind VTL requires the specific HPE driver to operate. Could you please try installing it?

Thanks for your update! Can you please install the HPE drivers https://www.starwindsoftware.com/resour ... ended%20to ?

If you can manage StarWind VTL through the GUI, then you might have a TRIAL or commercial key. In both cases, you can get support (for commercial only if you have an active support contract, though). Please also let me know what drivers you have for the HPE Tape driver Could you please pull the logs...

Try the software that supports instant recovery.

Good point, but, sadly, the Free version does not allow for the console.

Form what I found out recently, 32 bit does not exist, unfotunately.

We discussed your request internally, and interoperability with WSL was not tested and is not considered a production scenario.
The system does not align with what we recommend for the setups.

Welcome to StarWind Forum.
Did you also run into the same issue? If so, did you also try with the latest build?

It has to be done on the user side, not on the software side, as VMware tools not necessarily is a source of an issue. I'd view the issue in broad terms and connect it to the drivers or something within the VM that does not let it boot on the destination host.

You are welcome

Thanks for sharing! Check this out https://www.erniecosta.com/2020/02/26/how-to-p2v-a-windows-xp-machine-disable-sata-boot-drivers-and-enable-ide-boot-drivers/. As a side note, StarWind V2V transfers the data between VM formats. If the data is there but the OS does not start, there can be a driver m...

Thanks for your questions. I will discuss your request internally.
P.S. WiFi adapter will be a source of stability and performance issues. There's no benefit of using NVMe-oF in such a setup IMO.

Welcome to StarWind Forum and thanks for your questions! 1. I saw we should be removing VMTools before the conversion. Yes? 2. Do we have to remove the PVSCSI & VMNET3 hardware before the conversion and load the LSI SAS & E1000 nic? Only if the VMs do not boot up after conversion (applies on...

The output says 'None'. Please arm the key.