sorry then i got a bit mislead by the ZFS and G-Raid Option If you have GRAID, the configuration process looks different. If you have GRAID, the hardware is to be passed into CVM and configured inside the CVM. So i have done it like this for test? The configuration, like you showed earlier, allows ...

Or shall the concept bei to Just add Them as Single Disks and all raid Logic is Not Done node wide But Like in ceph Distributed through all disks? You can just create a HA device on each individual disk. So for the Future when we Plan to have 8 - 12 Disks how do i do Then? ZFS local in proxmox and ...

Plugin "PVE::Storage::Custom::StarLvmPlugin" is implementing an older storage API, an upgrade is recommended No, it is not a problem. I discovered I can't just migrate the disks from the old LVM to the new one, I suppose its convert to each disk to .qcow2 and then upload to the swlun?? Ye...

Welcome to StarWind Forum. Adding the VM disks in RAID will cause tons of overhead. That's why software RAID is not possible in a GUI. You can still RAID them via CLI, but it is not recommended.

Sadly, it is a destructive procedure.
UPD: QCOW cannot be created.

For CVM, you need to install and set up the VSAN plugin in Proxmox (recreating the LVM will be needed) https://www.starwindsoftware.com/resour ... ion-guide/

Please try a bigger value like the original comment suggests.

Welcome to StarWind Forum!
It should be.

I believe it needs RoCE.

That's a good point.

You are always welcome

The destination ends up with the same set of data as the source.
At the beginning, the converter takes a VSS snapshot of the storage. The data that is altered is merged afterward to the destination.

P2V uses VSS. Source will be the same as the destination the moment conversion is over.

Welcome to StarWind Forum. P2V conversion can be done live and it is non-disruptive for the source data. Good luck with your project.

There are system requirements. For the sake of system stability, the networking must meet them. Please also refer to the guides under https://www.starwindsoftware.com/resource-library/resource-type/technical_papers/ to see how the system is configured. Also, I'd strongly recommend having a call with...