Solved Thank you, the problem that i was trying to connect to the target from one servers, where another server is connected, so it keeps refuse the connection.
thanks Starwind support team.

Any help,,,,

I tried to install the software on another server (2012 R2) and got the same problem i also saw this error in windows event viewer (Login request failed. The login response packet is given in the dump data.) I also double cjecked that i can telnet the ports 33269, 33268, 3260 since the FW is OFF.

No, Tape Drive is not being in use by any other application.

Yes i can see the device as single device in device manager.
the model is HP DDS4 USB (USB Tape Drive).
the persistent path i exist (eUSBSTOR\SEQUENTIAL&VEN_HP&PROD_C5683A&REV_YU8B\48553106014E5547&0)

I'm trying to configure starwind tape redirector to connect VM's running on Hyper v to tape drive through Iscsi connection, when i installed the SW. I created the target and connected the tape device to it, but i'm unable to connect through iscsi initiator i got authorization failure, when i remove ...

below is event when i try to connect to the target from a remote machine, keep in your mind that i still cant see any new devices in device manager except tape drive, and their is no authontication required, 4/29 12:00:55.728 3460 Srv: Accepted iSCSI connection from 100.110.13.251:49712 to 100.100.2...

when i connect the tape drive to the server i see the tape in device manager. when i connect to in the Iscsi initiator while the tape is connected in the target i got authorization failure, so i deattached the tape from the target then i were able to connect in the initiator,then i reattached the ta...

Actually I finished connecting the tape to the target and followed the steps in the following URL http://www.starwindsoftware.com/using-starwind-tape-redirector-and-ca-arcserve-backup , but i cant find the disk in the disk managment and either in the device manager ( I can see the tape but cant see ...

No I didnt.

Hello
I instaled Tape Redirector on Hyper V 2012 R2, i can connect to tape in the target but i cant see the new iscsi disk drive in the disck managment, how can i solve this problem?