Thanks Anatoly, I noticed few times that the HA device was not available after a reboot. When I had look at management console, I found it was getting syncd. Could you please explain "Only the target that is synchronizing is closing connections," ? How do I know which device is the target ...

are my questions invalid ?

As promised I am back :-), I have setup a HA device for 80gb. It worked fine for some time but next time when I switched on the machines, the iSCSI initiator kept on showing "reconnecting". I had a look at management console and found that the device was being sync'd so may be because of t...

Thanks Anatoly, perhaps I got the answer but I'm sure I'll be back with more

what if any of these fails ? Shouldn't the other one function properly and re-sync the bad one when it gets changed ? That is exactly how it should work. Can you confirm that you see such behavior in your system? Here is some documentation that might be helpful for you: http://www.starwindsoftware....

Hello there, No, it doe`nt look OK, unfortunately. You need to connect to both SANs simultaneously (if the HA device is used of course). If you are using something else instead of HA devices I am strongly recommend to start using highly available storage. Thank you very much for your response. That...

Hello there, I have configured a HA device using starwind. For my application I am connecting through SAN1. In case SAN1 fails then I need to change it to SAN2 instead of SAN1 and when SAN1 comes up then it would be changed again after sync. My questions are: 1.) Is this ok to work like this ? or is...