In the Starwind technical paper, titled "StarWind Virtual SAN® Installation and Configuration of Hyper-Converged 2 Nodes with Hyper-V Cluster
DATE: JANUARY 2015", on page 35, step 13, it states "After both StarWind nodes are restarted and the MPIO support is enabled you have to configure the MPIO policy for each device specifying localhost (127.0.0.1) as the active path."
Do I do this for all discovered targets on the iSCSI initiator Targets tab, in the Discovered targets section? I have the 3 discovered targets for the local Witness, CSV1 and CSV2 targets plus the three replicated targets on the 2nd node. So, do I click on all 6 discovered targets, one at a time and with each target selected, click the Devices button,, then the MPIO button, then make the localhost path the active path. Even for the 3 targets on the other node?
And then, on the other node with the replicated devices, do I set all 6 of their MPIO paths to make the localhost path active on them as well?
It seems strange to make the targets on the remote server have an MPIO path of localhost active.
Thanks in advance for any help.
Dave
The Latest Gartner® Magic Quadrant™Hyperconverged Infrastructure Software