Initiator (iSCSI, FCoE, AoE, iSER and NVMe over Fabrics), iSCSI accelerator and RAM disk
Moderators: anton (staff), art (staff), Max (staff), Anatoly (staff)
-
SpectrumEngineers
- Posts: 3
- Joined: Wed Jun 22, 2011 11:53 pm
Wed Jun 22, 2011 11:57 pm
Hi,
I set up my Coraid aoe SAN using starport aoe driver. I noticed today that it is now starwind aoe free. How do I go about upgrading without affecting the SAN? Is there a document or any instructions?
Thanks,
Scott
-
anton (staff)
- Site Admin
- Posts: 4010
- Joined: Fri Jun 18, 2004 12:03 am
- Location: British Virgin Islands
-
Contact:
Thu Jun 23, 2011 6:41 am
Uninstall old version and install new one. StarWind AoE Free is basically stripped down version of StarPort (we've separated products on SAN protocol basis) so everything inside the GUI and setup is pretty much the same. Just updated version of binaries for storage controller and raw Ethernet access module.
Regards,
Anton Kolomyeytsev
Chief Technology Officer & Chief Architect, StarWind Software